Electrician using a tester on breakers in an open panel

7 Signs Your Electrical Panel Needs an Upgrade

By Soares LiteOn Electric · · 3 min read

Your electrical panel sends power to every circuit in the house. When it is too small, too old or worn out, the warning signs are usually easy to spot once you know them.

1. Breakers trip again and again

A breaker that trips once in a while is doing its job. A breaker that trips every time you run the microwave and the toaster together is telling you the circuit or the panel is overloaded.

2. Lights dim or flicker

Lights that dim when a large appliance starts can point to overloaded circuits, loose connections or a service that no longer matches what the house uses.

3. The panel feels warm or smells hot

A panel cover that feels warm, a burning smell or discolored breakers are serious warnings. Stop using the affected circuits and call an electrician right away.

4. You still have fuses

Older fuse boxes were designed for far fewer appliances than a modern home runs. Many homeowners replace them with a breaker panel during a remodel or before adding new loads.

5. You are adding big new loads

An EV charger, a heat pump, a hot tub or a kitchen remodel can add more demand than an older panel was sized for. Plan the panel before you buy the equipment.

6. There are no open spaces left

A panel with every slot full, or with many tandem breakers, makes each new circuit harder to add safely.

7. Rust, water or damage

Corrosion, water stains or physical damage inside or around the panel need a professional look, especially after storms.

What to do next

If you notice any of these signs, a licensed electrician can check the panel, the service and the connections, and tell you whether a repair or an upgrade makes sense. See our upgrades & renovation service or request a free estimate.

This article gives general information. Electrical work should be done by a licensed electrician.

FAQ

Quick answers.

Still have a question? Call (774) 836-6834 or send us a message.

Ask a Question

Is a panel upgrade a do-it-yourself job?

No. Panel work involves the service conductors that stay energized even with the main breaker off. In Massachusetts it must be done by a licensed electrician.

Can a panel upgrade happen during a remodel?

Yes, and it often makes sense, because new circuits for the remodel can be planned into the new panel at the same time.

Photos on this site are from stock libraries and show example work until our own project photos are published.

Call Free Estimate